Entering Names In The Directory - Comelit Ikall-Serie Technisches Handbuch

1.2 Searching for devices to configure
√ Connect the Touch module to the computer (see page 23) and open ViP
Manager
In Options (1)/Local connections (2) select the correct network interface (3)
in accordance with the method used to connect the computer and the touch
module (Micro-USB, LAN, Bluetooth). Confirm by clicking OK (4).
Click Scan system (5) to start searching for devices.
Remote NDIS
based Internet
Sharing Device
Micro-
USB
Ethernet card
LAN
Bluetooth Device
(Personal Area
Bluetooth
network)
1.3

Entering names in the directory

1. Select Directories/Name directory
2. Enter the information required (at least one "ViP Address" and one
"Name" need to be filled out for each contact)
3. Click "Write page" to send the data to the Touch module
1.4 Changing the call layout
Name directory Custom direct
call
LOCK-RELEASE LOCK-RELEASE
LOCK-RELEASE LOCK-RELEASE
Antonio Rossi
Hans Schneider 7 2
Lisa Parker
Mik Parker
1 2 3
Lisa Rossi
5 6
4
Marco Bianchi
7 8 9
0
Lisa Schneider
Carlo Motta
John Lee
1. Select Layout/Settings
2. Select the "Layout type" from the drop-down menu
3. Click "Write page"to send the new configuration to the Touch module
If the selected layout is "name directory" and the number
of users stored is between 1 and 6, the size of the call
buttons will automatically adapt to the screen size
24
ViP Name
address
00000332 Antonio Rossi
Search by name Dual-button
name directory
LOCK-RELEASE LOCK-RELEASE
LOCK-RELEASE LOCK-RELEASE
Search name Search
Antonio Rossi Andy
Lisa Schneider
Hans Schneider
Carlo Motta
Lisa Parker Marco Bianchi
Mik Parker
Lisa Rossi
Lisa Rossi
Marco Bianchi Marco Bianchi
1 2 3 4 5 6 7 8 9 0
Lisa Schneider Lisa Schneider
Carlo Motta Carlo Motta
Q W E R T Y U I O P
A S D F G H J K L
#_* Z X C V B N M John Lee John Lee
1.5 Restoring the micro-SD card configuration
The micro-SD card provided can be used to save all the settings and logs for
Touch module art. 3456.
This data is updated once a day.
If the module is replaced, these settings can be copied to a new Touch module
as follows:
1. Remove the micro-SD card from the Touch module being replaced
2. Insert it into the computer using the special adapter provided
3. Connect the new Touch module to the computer and connect to the latter
using a USB/micro-USB cable and the ViP Manager software
4. Search for the device to configure as described on page 24
5. Use the mouse to right-click on the Touch module
6. Select "Reset configuration"
7. Select the restore file on the micro-SD card:
backup/XX-XX-XX_bkp.tar.gz
8. Remove the micro-SD card from the computer