STIEBEL ELTRON DHE 21 SLi Gebrauchs- Und Montageanleitung Seite 31

INSTALLATION
Installation
Installing the appliance
18 21 24
kW
f For easy installation, push the cable grommet of the upper f
electrical connection into the back panel from behind.
f Remove the transport plugs from the water connections. f
f Remove the fixing toggle from the upper part of the back f
panel.
f Route the power cable from behind through the cable grom- f
met until it rests against the cable sheath. Align the power
cable.
In the case of a cross-section > 6 mm², enlarge the hole in
the cable grommet.
f Push the appliance over the threaded stud of the mounting f
bracket, so that it breaks through the soft seal. If necessary,
use a screwdriver.
f Push the fixing toggle onto the threaded stud of the mount- f
ing bracket.
f Press the back panel firmly into place and lock the fixing tog- f
gle by turning it clockwise through 90°.
19
f Fit the pipes with flat gaskets onto the twin connectors. f
www.stiebel-eltron.com
24
Connecting the power supply
WARNING Electrocution
Carry out all electrical connection and installation work
in accordance with relevant regulations.
WARNING Electrocution
Connection to the power supply is only permissible in
the form of a permanent connection in conjunction with
the removable cable grommet. Ensure that the appliance
can be separated from the power supply by an isolator
that disconnects all poles with at least 3 mm contact
separation.
WARNING Electrocution
Ensure that the appliance is earthed.
f Connect the power cable to the mains terminal (see chapter f
"Specification / Wiring diagram"). The specified voltage must
match the mains voltage.
Connected load options
Up to 3 connected load stages can be selected, subject to appliance
type. The middle load is preset. If you wish to select a different
load, please follow the steps below.
18 21 24
kW
f Select the connected load you require (see chapter "Specifi- f
cation / Data table").
f Replug the coding card in accordance with the selected con- f
nected load.
f Change the type plate. Tick the selected connected load. f
Please use a ballpoint pen to do this.
DHE SLi | 31