Lighting The Burners - CAN SL-Serie Handbuch Für Installation, Betrieb Und Wartung

OFF
MAX
MIN

LIGHTING THE BURNERS

ATTENTION!
Before use, make sure that the burner spreaders, caps and pan holders are positioned properly.
The matching burner is indicated on each knob.
The burner can be lit:
▪
manually using the external igniter (on S versions),
▪
piezoelectrically with mechanically/manually operated piezoelectric igniter (on P versions).
Proceed as follows to light the burner:
step
1 press the knob corresponding to the burner you
want to light and turn it anticlockwise (to the
maximum symbol).
2 At the same time, operate the piezoelectric
igniter with several fast repeated pulses, or
bring an external manual igniter close to the
burner spreader.
3 When lit, keep the knob pressed all the way
for another 5 seconds (at maximum) and then
release it, adjusting the desired intensity of the
flame.
Please note: this delay in releasing the knob
heats up the safety thermocouple.
If the burner does not remain lit when you release the knob, it means that the thermocouple did not heat
up sufficiently. To solve this problem, repeat the operations described in the table, holding the knob down
longer after the burner is lit.
/
use of gas burners
burner spreader positioning
action
Installation, use and maintenance instruction manual
controls and their symbols
1
2
▪
Ed. 11/2019 Rev. 00
63