Maintenance And Cleaning - CAN SL-Serie Handbuch Für Installation, Betrieb Und Wartung

OUTSIDE REMOVABLE GAS HOB UNITS ▪

MAINTENANCE AND CLEANING

No specific maintenance procedures are required for the appliance aside from correct and
regular cleaning.
ATTENTION!
Before cleaning the appliance, make sure that the burner is off.
Always wait for the appliance to completely cool down.
▪
Clean the appliance on a regular basis to prevent the materials making up the surface from deteriorating.
▪
Disconnect the power (if on) and close the gas supply cocks before any cleaning operation or when
expected to remain idle for a long time. Make sure that all the knobs are always in the "off" position
when you are finished using the appliance.
▪
Do not use steam appliances or direct water jets to clean the hob unit.
ATTENTION!
Do not use hydrochloric acid (muriatic acid and/or detergents containing chlorides) on the
stainless steel surfaces.
ATTENTION!
Not use abrasive powder detergents which could ruin the appearance of the surface finish.
If some particularly acidic substances (e.g. vinegar, lemon juice, etc.) remain on the appliance
for a long time, they could corrode the surfaces creating unsightly rings which however do not
jeopardise appliance operation.
type of cleaning
STAINLESS STEEL SURFACES
BURNER SPREADER/CAPS
KNOBS
ATTENTION!
During and after cleaning, check that no nozzle hole is obstructed by impurities or whether
any detergent residues remain at the bottom of the burner cups. If so, remove the impurities
and residues by vacuuming them, without using liquid detergent or similar.
66
Use a soft cloth slightly soaked in specific neutral detergent or warm
vinegar. Rinse with warm water and dry.
Please note: follow the manufacturer's instructions to see how to use the
cleaning products).
Remove the components from their housing and wash them with warm
water and dishwashing soap. Stubborn filth on the enamelled components
can be removed using a slightly abrasive sponge and a degreaser, taking
care not to damage the surfaces.
Rinse with warm water and dry. Afterwards, put the components back in
place with the utmost attention.
Use a soft cloth slightly soaked in neutral detergent.
Make sure that the detergent does not leak under the knobs.
Do not remove the knobs from the pin they are mounted on.
Please note: follow the manufacturer's instructions to see how to use the
cleaning products).
SL series
description