Lighting The Burners - CAN FL series Handbuch Für Installation, Gebrauch Und Wartung

OFF
MAX
MIN

LIGHTING THE BURNERS

ATTENTION!
Before use, make sure that the burner spreaders, caps and pan holders are positioned properly.
The matching burner is indicated on each knob.
The burner can be lit:
▪
manually using the external igniter (on S versions),
▪
electronically with 12 V/DC generator (on E versions),
▪
piezoelectrically with mechanically/manually operated piezoelectric igniter (on P versions).
Proceed as follows to light the burner:
step
1 Press the knob corresponding to the burner you
want to light and turn it anticlockwise (until the
maximum symbol).
2 Simultaneously,
piezoelectric) lighting device with several fast
repeated pulses.
3 When lit, keep the knob pressed all the way for
another 5 seconds (at maximum) and then release
it, adjusting the desired intensity of the flame.
Please note: this delay in releasing the knob heats
up the safety thermocouple.
If the burner does not remain lit when you release the knob, it means that the thermocouple was not
preheated sufficiently. To solve this problem, repeat the operations described in the table, keeping the knob
pressed longer after the burner has lit.
use of burners
burner spreader positioning
action
activate the electric
Installation, use and maintenance instruction manual
(or
1
2
▪
Ed. 02/2019 Rev. 01
65