Use - CAN SL-Serie Handbuch Für Installation, Betrieb Und Wartung

OUTSIDE REMOVABLE GAS HOB UNITS ▪
step
1 Open the installation recess, release the sliding
base (by lowering both safety levers located
at the end of each guide) and remove the
appliance.
2 Continue removing the product until the end
stop position has been reached: the guides will
automatically lock preventing the base from
being even accidentally slid.
Lift the glass cover of the product.
3 Grasp the free end of the flexible gas hose
and connect the quick joint to the appropriate
approved external valve (as shown in the
figure). Upon proper coupling, a mechanical
click is heard.
Then turn the knob of the safety valve installed
to check for proper quick joint, and power the
appliance.
For F versions, it is sufficient to check the product for stability when it is mounted on legs, and
ensure it is properly connected to the external gas cylinder.

USE

Before using the appliance for the first time, clean it and all of its components as instructed
in the paragraph "Cleaning".
The first few times the appliance is used, it could release smoke and unpleasant smells.
There is no reason for concern as this is due to the combustion of the grease used to process it in the
factory.
The burners are equipped with safety thermocouple.
The thermocouple is a heat sensitive device: as long as it is heated by the fire of the lit burner, it
allows gas to exit the nozzle; if the fire goes out accidentally (for example when liquid spills from
the pan), the thermocouple will cool off in a few seconds, thus preventing gas from exiting the
nozzle.
62
action
SL series
picture