Instructions For The Installer; Installation Method - Version O; Recessed Installation On A Suitable Support Structure; Installation Recess/Storage Features - CAN SL-Serie Handbuch Für Installation, Betrieb Und Wartung

INSTRUCTIONS FOR THE INSTALLER

ATTENTION!
Installation and all operations on the appliance described in this instruction manual must be
carried out by qualified technical personnel and in compliance with the standards in force.
ATTENTION!
Always wear suitable personal protective equipment (PPE) according to the type of operation/
process in progress.
ATTENTION!
The gas connection systems and the installation sites must be suitable and meet the safety
standards in force in the Country of use.
ATTENTION!
During installation, maintenance or repair operations, always close the main gas valves, so
that the gas supply line to the hob unit is "GAS FREE" and there is no risk of fire/explosion or
poisoning/suffocation.
ATTENTION!
If there is also an electrical connection, make sure that you have insulated the power supply
line to prevent the installer from risking any electric shocks.
▪
Do not install or use the appliance if damaged.
▪
Comply with the minimum safety distances from flammable surfaces, panelling, verandas/awnings,
fuel tanks/vents, or any other container with flammable or explosive substances (see paragraphs
"Minimum safety distances").
▪
The appliance is delivered with a quick-joint flexible hose (version O) and must be used only outdoors
with an approved outdoor gas valve in accordance with EN 1949, of a type that is compatible with
the quick joint supplied.
▪
The appliance, fitted with an appropriate national gas coupling (F version), must be connected to
an external gas cylinder equipped with a suitable pressure regulator meeting the power supply
requirements of the appliance as per EN 484:2019.

INSTALLATION METHOD - VERSION O

RECESSED INSTALLATION ON A SUITABLE SUPPORT STRUCTURE

INSTALLATION RECESS/STORAGE FEATURES

The appliance must be installed in a well-ventilated recess that is separated from internal rooms and
living spaces. One of the recess sides must be connected to the outside and provided with a door that is
adequately sized for the product to be fully removed, and such as to ensure excellent weather tightness
(water, wind, humidity). The recess must be built with sturdy materials, suitable for the intended purpose,
which will not deteriorate over time in the event of exposure, even partial, to the action of atmospheric
agents.
ATTENTION!
The recess is only intended for housing the product (disconnected from the gas/water mains)
when the vehicle or boat it is installed on is moving. Before placing the product into the recess, it
must be disconnected from any mains or system to which it is connected during use.
38