Scheppach HC550TC 400V Original Bedienungsanleitung Seite 24

- Check extension cables regularly and replace
them when damaged.
10. Pull the connector out of the socket
- When the power tool is not in use or prior to
maintenance and when replacing tools such as
saw blades, bits, milling heads.
11. Avoid inadvertent starting
- Make sure that the switch is switched off when
plugging the plug into an outlet.
12. Use extension cables for outdoors
- Only use approved and appropriately identified
extension cables for use outdoors.
- Only use cable reels in the unrolled state.
13. Always remain attentive
- Pay attention to what you are doing. Remain
sensible when working. Do not use the power
tool when you are distracted.
14. Check the power tool for potential damage
- Protective devices or other parts with minor
damage must be carefully inspected to ensure
that they function correctly and as intended
prior to continued use of the power tool.
- Check whether the moving parts function
faultlessly and do not jam or whether parts are
damaged. All parts must be correctly mounted
and all conditions must be fulfilled to ensure
fault-free operation of the power tool.
- Damaged protective devices and parts must be
properly repaired or replaced by a recognised
workshop, insofar as nothing different is
specified in the operating manual.
- Damaged switches must be replaced at a
customer service workshop.
- Do not use any faulty or damaged connection
cables.
- Do not use any power tool on which the switch
cannot be switched on and off.
15. Have your power tool repaired by a qualified
electrician
- This power tool conforms to the applicable
safety regulations. Repairs may only be
performed by an electrician using original spare
parts. Otherwise accidents can occur.
16. Attention!
- For your own safety, only use accessories and
additional equipment that are indicated in the
operating manual or have been recommended
or indicated by the manufacturer. Use of other
tools or accessories that those recommended
in the operating manual or in the catalogue
could represent a personal danger to you.
24 | GB
17. Noise
- Wear hearing protection when using the
compressor.
18. Replacing the connection line
- If the connection line is damaged, it must be
replaced by the manufacturer or an electrician
to avoid danger. There is a risk of electric shock.
19. Inflating tyres
- Directly after inflating tyres, check the pressure
with a suitable pressure gauge, for example at
your filling station.
20. Street-legal compressors in construction site
operation
- Ensure that all hoses and fixtures are suitable
for the maximum permissible working pressure
of the compressor.
21. Set-up location
- Only set up the compressor on a flat surface.
22. It is recommended to equip the feed hoses with a
safety cable in cases where the pressure is above
7 bar, e.g. using a wire cable.
23. Avoid over-stressing the piping system by using
flexible hose connections to prevent kinking.
24. Make sure that the oil cooling devices are kept
clean and that the protective devices are kept in
good operating condition.
25. Risk of burns from hot oil
- Wear suitable protective gloves.
- Never work with the compressor near naked
flames.
- Be careful not to spill oil.
26. Starting the motor is forbidden if the temperature
is below 0°C.
Additional safety instructions
Observe the corresponding operating manuals of
the respective compressed air tools / compressed
air attachments! The following general instructions
must also be observed:
Safety instructions for working with compressed
air and blasting guns
• Ensure there is sufficient distance to the product, at
least 2.50 m, and keep the compressed air tools /
compressed air attachments away from the com-
pressor during operation.
• The compressor pump and lines can become very
hot during operation. Touching these parts will burn
you.
www.scheppach.com