Inhaltsverzeichnis
Werbung
Transport and storage
The packaging of the awning must be protec-
ted against wet and damp. Soaked packaging
can come loose and cause accidents.
Transport the awning to the place of instal-
lation in the correct direction for fitting to
prevent turning it in small spaces.
If the awning is to be installed in an elevated
area, the area underneath must be blocked
off when the awning is raised so that nobody
is under the suspended load.
Proceed in the same manner when uninstal-
ling the awning.
The awning must be protected against
penetrating damp when in storage!
Awnings must be stacked and unstacked so
that they do not prove a hazard to persons
due to tipping over or rolling out of position.
Only create storage facilities and stacks
that can securely take the load. Ensure that
the permissible loads of shelves and other
load-bearing components are not excee-
ded.
You must comply with the general goods
storage principles.
Fixing material
The awning is delivered without any
fixing material
The fixing material must be selected by the
fitter to suit the existing fitting base and
reconciled in accordance with the require-
ments of the system and fitting base.
You must comply with the specifications for
the required screw anchor pull-out forces.
When using the fixing material ordered as
fitting accessories, we do not assume any
liability for professional fitting. The fitter is
solely responsible to ensure that the fixing
material is suitable for the respective fitting
base and that the fitting is done professio-
nally.
You must adhere to the respective fitting
Sicherheitshinweise • Safety instructions
instructions of the screw anchor manufactu-
rers!
Test run
Persons must not stand in the moving area
or beneath the awning when it is extended
for the first time. The fixing materials and
consoles must be visually inspected after the
first extension.
Installation
You need the following equipment in order
to guarantee that the awning is properly
fitted, and therefore the optimal functioning
of the finished product:
Cordless screwdriver
• Drill
• Spirit level
• Ropes / belts
• Complete tool kit
• Equipment for working at height (scaf-
folding, ladders, cherry picker, etc.) that
meet the current individual occupational
health and safety standards.
Apply a maximum force of 20 Nm (= 2 kgm)
when tightening all screws used for alumini-
um components.
A greater tightening force may damage
the components and/or the stainless steel
screws.
It is recommended to use torque wrenches
and screwdrivers.
Use electric screwdrivers with a slow speed.
Threads may get jammed if driven in at
too fast a speed, particularly stainless steel
screws and threads that are driven into alu-
minium.
Ensure that all screws are tightened evenly.
Uneven tightening can result in tension in
the aluminium and cast components as well
in the brickwork and therefore lead to failure
of the attachments.
www.paramondo.de
11
Werbung
Inhaltsverzeichnis
