Evaluating Results - Beurer BM 58 Gebrauchsanleitung

• Rest for approx. 5 minutes before each measurement.
Otherwise there may be divergences.
• You can perform the measurement either sitting or lying
down. Always make sure that the cuff is on a level with
your heart.
• In order not to distort the result, it is important to keep
still during the measurement and not talk.
Measuring blood pressure
• Move the touch screen activation switch to the "ON"
position.
• Put on the cuff as described previously and assume the
position in which you want to carry out the measurement.
• Switch on the blood pressure monitor with the "START/
STOP" button. After the full-screen display, the most re-
cently used user memory appears (
the user memory, press the "MEM" button and confirm
your selection with the "START/STOP" button. If no
button is pressed, the most recently used user memory is
automatically used after 5 seconds.
• Before the measurement, the last saved test result is brief-
ly displayed. If there is no measurement in the memory,
the instrument always displays the value "0".
• The cuff is pumped up to 190 mmHg. Cuff air pressure is
released slowly.
If a tendency towards high blood pressure is already
detectable, the cuff is pumped up again and cuff pressure
• Heart rate, systolic and diastolic blood pressure are dis-
• You can cancel the measurement at any time by pres-
• "Er" appears if it has not been possible to perform the
• The test result is saved automatically.
• To switch off the device, press the "START/STOP" button
or ). To change
Wait at least 5 minutes before taking another measurement!

6. evaluating results

Cardiac arrhythmia:
This instrument can identify possible cardiac arrhythmia
disorders during measurement and if necessary indicates
the measurement with the flashing icon
This may be an indicator for arrhythmia. Arrhythmia is a
condition where the heart rhythm is abnormal as a result
of defects in the bioelectrical system controlling the heart
beat. The symptoms (omitted or premature heart beats,
19
increased further. As soon as a heart rate is detected, the
heart rate symbol is displayed.
played.
sing the "START/STOP" button or by pushing the touch
screen activation button to "OFF".
measurement properly. Observe the section in these in-
structions on error messages/troubleshooting and repeat
the measurement.
or push the touch screen activation switch to "OFF". If
you forget to switch off the device, it switches off auto-
matically after approx. 1 minute.
.