Problems, Causes And Solutions; Demolition And Disposal - Maschio Gaspardo BISONTE 220 Gebrauch Und Wartung

ENGLISH

5.2 PROBLEMS, CAUSES AND SOLUTIONS

INCONVENIENCE
Excessive vibration.
1)
2)
3)
4)
Imperfect cut due to low-
1)
ering of engine speed.
2)
Overheating of belts.
1)
2)
Overheating of bevel
1)
gear pair.
2)
Rapid wearing of blades
1)
or hammers.
Loss of oil from transmis-
1)
sion, belt side.
Deformation of the sup-
1)
ports of the roller or
wheels.
Deformation of protec-
1)
tive guards.

6.0 DEMOLITION AND DISPOSAL

This operation is to be carried out by the customer.
Before demolishing the machine, you are advised to carefully check its physical condition and ascertain whether there are
any parts of the structure that may be susceptible to structural collapse or breakage during demolition.
The customer should operate in compliance with the environment protection laws in force in his/her country.
CRUSHING AND SHEARING HAZARD. POTENTIAL SERIOUS INJURIES OR DEATH.
The machine demolition operations should be carried out by skilled personnel only, equipped with suitable pro-
tective clothing (safety footwear and gloves) and auxiliary tools and equipment. All the disassembly operations
for demolition should be carried out with the machine stopped and detached from the tractor.
Before demolishing the machine, you are advised to render harmless all the parts that may be a source of danger and
therefore:
- scrap the structure using specialized fi rms,
- remove any electrical apparatus according to the laws in force,
- collect oils and greases separately, to be disposed of through specialized fi rms, in accordance with the regulations of
the country in which the machine was used.
When the machine is demolished the CE mark should be destroyed together with this manual.
Finally, we remind you that the manufacturer is always available for any and all necessary assistance and spares.
64 - EN
USE AND MAINTENANCE
CAUSE
Breakage or excessive wear of blades and
hammers.
Blades or hammers blocked on pin.
Inadequate balancing of rotor.
Wear of rotor bearings.
Belt tension insuffi cient.
Belts excessively worn.
Incorrect tension of belts.
Transmission axis and rotor axis out of alignment.
Lack of oil.
Oil depleted..
Work position too low, blades touching ground.
Wear and breakage of oil seal..
The supports of the roller and the wheels have
undergone side stress.
In order to assume the work position, the ma-
chine - from a raised position (transport) - has
been lowered onto the material to be shredded .
1) Replace the worn or cracked pieces.
2) Clean and grease the pins.
3) Check the weight of the of the blades/ham-
mers block
Remove and replace bearings and seals.
4)
Regulate tension.
1)
Replace belts.
2)
Check tension.
1)
Check alignment.
2)
Add oil to proper level.
1)
Replace
2)
1) Adjust height of rotor from ground.
Replace seal.
1)
Raise the machine from the ground when in
1)
reverse gear.
The machine must be in the work position
1)
before touching the material to be shredded.
ATTENTION
REMEDY
cod. F07011705