Preparation (Indoor Unit • Remote Control) - Panasonic CS-G95KE Bedienungsanleitung

Preparation (Indoor Unit • Remote Control)
Indoor Unit
1
Insert the power supply plug into an
electrical outlet and open the front
panel.
2
Remove the air filters and insert the
air purifying filters.
Air filters
Air purifying filters
Use under the following conditions:
DBT: Dry Bulb Temperature
WBT: Wet Bulb Temperature
Indoor
Outdoor
Indoor
Outdoor
Notes
• If the unit is not going to be used for an extended period of time, turn off the
Power Supply. If it is left at the ON position, approximately 2.8 W of electricity
will be used even if the indoor unit has been turned off with the remote control.
When standby mode is activated, approximately 35 W of electric power will be
consumed on the heat of compressor to warm up the room quickly. This mode
can be switched off if you do not require it. Please consult your dealer.
• If operation is stopped, then restarted immediately, the unit will resume
operation only after 3 minutes.
8
Hold the panel openers
and pull.
3
Lift up slightly,
then pull down.
Insert the new
air purifying
filters. (Be sure
the "FRONT"
mark is facing
you).
Max. Temperature
DBT 32
WBT 23
DBT 43
WBT 26
DBT 30
WBT
DBT 24
WBT 18
!
Warning
Ensure that the power supply
plug is securely inserted.
A loose plug may cause a fire or an electric
shock.
Insert the air filters and close the front
panel.
–
Unit in °C
Min. Temperature
16
11
16
11
2
–
–5
–6
3 min.