Panasonic TY-WK3L2RW Anleitung Zur Anbringung Seite 7

3. Installing the wall-hanging bracket on
the wall
• For details on the dimensions applying when the LCD TV is
mounted, refer to the outline drawing (on page 88-96).
Install the wall-hanging bracket so that the arrows indicated
on it are pointing upward.
First of all, secure the screw in the upper center hole
Use a level to ensure that the fixture is not tilting on one
side, and then secure the screws in the five remaining
holes.
Notes
• If it is necessary to embed screws or nuts in the wall prior to
installing the wall-hanging bracket because the wall is made of
concrete or such other materials, determine the positions of the
holes by fitting the actual wall-hanging bracket or calculating
from the figures shown in the outline drawing, and then embed
screws or nuts with a nominal diameter of 6 mm (0.2 inches) or
their equivalent. If you are embedding the screws, make sure they
protrude from the wall surface by 10 to 15 mm (0.4 to 0.6 inches).
• For the wall mounting screws, use commercially available screws
with a nominal diameter of 6 mm (0.2 inches) that are suited to the
material/structure to which you are fitting the bracket.
• Anchor the screws in at least six locations.
• Check the strength of the mounting screws. Use screws that are
sufficiently strong.
4. Adjusting the angle of the wall-hanging bracket
The angle of this wall-hanging bracket can be adjusted in 5-degree increments to one of five positions ranging
from "Zero tilting" to "20-degree tilting". However, when installing an LCD TV with any of the following model
numbers, the angle can be adjusted to either of two positions of "Zero tilting" and "5-degree tilting".
(L42D Series / L37D Series / L37W Series / L37V Series / L32D Series For details on each model, refer to the
External dimensions table. (on page 88-96))
When the wall-hanging bracket is shipped from the manufacturing plant, the angle is set to "Zero tilting". To
change this angle, remove the screws used for adjustment and change the position of the stay.
(Tightening torque: 1.2 to 1.5 N•m)
"20-degree tilting"
"Zero tilting"
"15-degree tilting"
"10-degree tilting"
"5-degree tilting"
Note
• When using some types of HDMI cables or PC cables, the cable may touch the wall and cause damage to the HDMI
terminal or the PC input terminal on the television set.
In such a case, adjust the angle of the wall-hanging bracket so that no weight is applied to the cable.
Stay
"Zero tilting"
Tilting from 5 to
20 degrees
Arrows
.
When the angle is set to
"Zero tilting"
Screw used for
adjustment.
When the angle is set to
"15-degree tilting"
7