Panasonic TY-WK3L2RW Anleitung Zur Anbringung Seite 5

Components
TY-WK3L2RW
Parts used to assemble the wall-hanging bracket
Base upper fitting (1)
A
Cutouts farther apart
Base lower fitting
B
Cutouts closer together
Parts used for installation
View of fully assembled
fixtur
Precautions for wall-hanging bracket fitting
Installation and removal work must be carried out only by a qualified technician.
If the unit is installed or removed improperly, the display may fall down and personal injury may result.
The wall-hanging bracket is for use in attaching a LCD TV unit to a vertical wall for viewing. Do not fit to any
surface other than a vertical wall.
To ensure correct LCD TV performance and prevent trouble, do not fit at any of the following locations.
• Near sprinklers or fire/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form
Fit using techniques suited to the structure and materials of the fitting location.
Use commercially available screws with a nominal diameter of 6 mm (0.2 inches) that are suited to the wall
material (wood, steel frame, concrete etc.) you are fitting the bracket to.
For the TV power supply plug, use a power supply outlet that can be reached easily.
Ensure good air flow so that the equipment ambient temperature does not exceed 40 °C (104 °F). Failure to
do this may cause heat to build up inside the LCD TV, resulting in malfunction.
Spread a soft blanket or cloth over the floor so that the LCD TV and floor will not be marked or scratched
during the assembly and installation work.
When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened.
Take sufficient care to ensure safety around you when performing the assembly and installation work or while
moving about during the course of the work.
Do not install the LCD TV underneath ceiling lamps (spotlights, halogen lamps, etc.). Otherwise, the cabinet
may be bent or damaged by high heat.
[ The images shown in this manual are for illustrative
purpose only.]
Wall-hanging bracket (Adjustable angle type)
Bracket base left fitting
L
(1)
32–42-inch models: A (M6 screw set)
M6×22 Allen head
countersunk screws
Dished toothed washers
Insulation spacers
Allen wrench (included tool)
M5x50 Screw for securing unit
Bracket base right fitting
(1)
Use the correct set of screws and attachment parts for
your size of LCD TV. However, use B (M4 screw set)
for L32D Series. For details on each model, refer to the
External dimensions table. (on page 88-96)
26-inch models, L32D Series: B (M4 screw set)
M4×19 Allen head
(4) countersunk screws
(4) Dished toothed washers
(4) Insulation spacers
Allen wrench (included tool)
(1)
(2)
M5x10 screws
(1) for assembling
the fixture (4)
R
(4)
(4)
(4)
(1)
5