Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FIXING THE SANDING HEAD
1
For processing upper walls you may
fixate the sanding head vertically. For
this hook the
spring 12
into the bolt at
the tube and into the eye at the motor.
EXTENSION
1
To use the extension tube, loosen the
dust hose
connector 8
and slide in the
extension tube.
Caution! Make sure the tool is
switched off and unplugged.
DUST HOSE
1
Loosen the dust hose connector
the tool or on the extension tube and
slide in the dust hose 7.
Never use the tool without a dust
collection system.
SANDING PAPER
1
Align the holes in the sanding paper
with the ones in the sanding pad
and press the sanding paper into place.
Caution! Make sure the tool is
switched off and unplugged.
SANDING ALONG EDGES
1
For sanding along edges press the re-
lease button and remove the protec-
tive cover. When re-installing the cover
insert it on the right first and then snap
it in on the left side.
Caution! Re-install the cover after
sanding along edges.
140
EN
RELEASING THE SANDING HEAD
2
Push down the hinge locking
until it clicks into place.
Pull the hinge locking lever to fold the
tool for storage.
2
Set the extension tube to the desired
length by sliding it in and out (observe
the max. marking).
Tighten the dust hose connector 8.
8
on
2
Tighten the dust hose connector
the tool or on the extension tube and
connect the
hose 7
to a suitable vacu-
um cleaner.
SANDING PAD
2
For cleaning purposes, the sanding
14
pad
14
can be removed using the al-
len key.
Re-install the sanding pad perfectly
centred.
SPEED SETTING
2
Use speed dial
4
to set the operation
speed:
MIN = 1000/min - MAX = 1800/min
lever 10
1
1
8
on
1
1
1
2
2
1. 1.
2. 2.
2
1. 1.
2. 2.
2
2
1. 1.
2. 2.
+ +
– –
EN
141
Werbung
Inhaltsverzeichnis
