Before Use - Parkside FCL-76003LI Bedienungsanleitung

Note: Remove all packaging materials from the product.
Note: Protect delicate surfaces before setting up the product.
26 GB/IE
3561_2010_par_LED-Arbeitsstrahler_A6_content_OS.indd 26 3561_2010_par_LED-Arbeitsstrahler_A6_content_OS.indd 26
Never leave the product unattended whilst in operation. Excessive
heat can result in fire.
The LED module is not dimmable.
Do not look directly into the light source (illuminant, LED etc.). Do
not look into the light source (illuminant, LED, etc.) with an optical
instrument (e.g. magnifying glass).
A shattered protective covering must always be
replaced.
Never aim the LED light beam at reflective surfaces or at people or
animals. Failure to observe this instruction can lead to eye injuries
and / or loss of sight in people or animals. Even a weak LED light
beam can cause eye damage.
Disconnect the product from the mains supply whenever you want
to set it up in a different location.
The product is not suitable for use as room lighting.

Before use

Fully unwind the mains cable (remove the cable tie).
Loosen the knurled screw
turning it anticlockwise, in order to move the fold-out stand
the desired position.
Then re-tighten the knurled screw
Set up the product in the desired location.
Note: The lamp head can be continuously tilted.
/ on the side of the product by
3a 3b
/ by turning it clockwise.
3a 3b
to
5
24.03.21 11:3 24.03.21 11:3