Before First-Time Use - Parkside PAS 10 A3 Bedienungs- Und Sicherheitshinweise

replaced; if it is damaged, the product must
be disposed of�
Fully unwind the cable before using the product�
„
You should only connect the product to an
„
easily accessible power outlet socket so that
you can quickly disconnect it from the
power supply in the event of a fault�
Always unplug the mains power cable
„
before assembling, dismantling or cleaning
the product�
Always disconnect the product from the
„
mains power supply if it is not going to be
used for an extended period (e.g. holiday)
or if you want to set it up in a different place�
Do not immerse the product in water or any
„
other liquids�
Keep the product away from naked flames
„
and hot surfaces�
Never tamper with or modify the product�
„
Do not open up the casing and only have
„
the product repaired by qualified
professionals� To that end you should
contact a specialist repairer� No liability or
warranty claims are accepted in cases
where repairs have been carried out by
unauthorised persons or the product has
been incorrectly wired or used�
Before using the product, make sure that the
„
mains power supply voltage matches the
supply voltage required by the product (see
„Technical data")�
AVOID THE RISK OF
FIRE AND INJURY!
RISK OF BURNS FROM HOT
SURFACES! To avoid the risk of
burns, make sure that the product is
switched off and has cooled down before
you touch it� Light sources generate a large
amount of heat�
Do not cover over the product with other objects�
„
Excessive heat build-up can cause a fire.
Do not leave the product unattended while in
„
use. Excessive heat build-up can cause a fire.
RISK OF INJURY! Incorrect
handling of the product may
8
GB/CY
potentially result in personal injury�
The LED module
„
cannot be dimmed�
Never look directly into the light source
„
(illuminant, LED, etc�)� Never look at the light
source (illuminant, LED, etc�) through an
optical instrument (e�g� magnifying glass)�
Should the protective cover be split or
„
cracked, it must be replaced�
Never direct the LED light beam at reflective
„
surfaces or towards people or animals�
Failure to follow the above instructions may
cause people or animals to suffer eye
injuries and/or to lose their sight� Even a
weak LED light beam is capable of causing
eye damage�
RISK OF DAMAGE! Improper
handling of the product may result
in damage to the product�
The light source may only be replaced by
„
the manufacturer, service technician or a
similarly qualified person.
Do not use the product if you notice any
„
damage�
z Before first-time use
Please note: Take the product out of its
packaging and remove all packing material�
Check that all package contents are
„
present�
Check if the product or individual parts are
„
damaged� Should you detect damage, do
not use the product� Please contact the
retailer via the service address indicated�
Setting up your product
The handle (see Fig� A) is intended for
1
moving the product to a different position�
The product must be disconnected from the
power supply while it is being moved�
Please note: Protect easily damaged
surfaces before setting up the product�
Fully unwind the power cable�
„ „
6