Dometic CT4050 Montageanleitung Seite 28

Installing the cassette toilet
6.7 Venting the cartridge tank (if a service door is
installed only)
Service door SK4 and SK5
1. In the niche floor, create an opening with a diameter of approx. 12 mm (fig. j,
page 14).
2. Run the vent hose into this opening for discharge to the outside.
Service door SK5 (optional)
1. Press the spray paint out of the inner frame of the door (fig. k, page 15).
2. Install the door.
3. Insert the hose of the vent into the integrated vent opening of the service door
and the cassette tank (fig. l, page 15).
6.8 Installing the tank flap
For the CTW4xxx model, mount a tank flap for the integrated water tank.
Proceed as follows (fig. m, page 16):
1. Using the template, create an opening in the outer wall.
2. Slide the O-ring onto the inner tube of the tank flap.
3. Grease the O-ring. This makes it easier for the filler neck to be connected with
the upper part of the tank.
4. Seal the tank flap watertight (with butyl rubber, for example).
5. Tightly fasten the tank flap with four C4x25 countersunk screws (not included).
6. Perform a leak test.
28
CT(E), CTLP, CT(E)S, CTW
EN