AEG Powertools WS 2200-180 Originalbetriebsanleitung Seite 15

j) Hold power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory may
contact hidden wiring or its own cord.
k) Position the cord clear of the spinning accessory.
l) Never lay the power tool down until the accessory has come to
a complete stop.
m) Do not run the power tool while carrying it at your side.
n) Regularly clean the power tool's air vents.
o) Do not operate the power tool near flammable materials.
p) Do not use accessories that require liquid coolants.
GB
Kickback and related warnings
a) Maintain a firm grip on the power tool and position your
body and arm to allow you to resist kickback forces. Always use
auxiliary handle, if provided, for maximum control over kickback
or torque reaction during start-up.
b) Never place your hand near the rotating accessory.
c) Do not position your body in the area where power tool will
move if kickback occurs.
d) Use special care when working corners, sharp edges, etc. Avoid
bouncing and snagging the accessory.
e) Do not attach a saw chain, woodcarving blade or toothed saw
blade.
Safety Warnings Specific for Grinding and Abrasive Cutting-Off
Operations:
a) Use only wheel types that are recommended for your power
tool and the specific guard designed for the selected wheel.
English
14
b) The guard must be securely attached to the power tool and
positioned for maximum safety, so the least amount of wheel is
exposed towards the operator.
c) Wheels must be used only for recommended applications. For
example: do not grind with the side of cut-off wheel.
d) Always use undamaged wheel flanges that are of correct size
and shape for your selected wheel.
e) Do not use worn down wheels from larger power tools.
Additional Safety Warnings Specific for Abrasive Cutting-Off
Operations:
a) Do not "jam" the cut-off wheel or apply excessive pressure. Do
not attempt to make an excessive depth of cut.
b) Do not position your body in line with and behind the rotating
wheel.
c) When wheel is binding or when interrupting a cut for any
reason, switch off the power tool and hold the power tool
motionless until the wheel comes to a complete stop. Never
attempt to remove the cut-off wheel from the cut while the
wheel is in motion otherwise kickback may occur.
d) Do not restart the cutting operation in the workpiece. Let
the wheel reach full speed and carefully reenter the cut.
e) Support panels or any oversized workpiece to minimize the risk
of wheel pinching and kickback.
f) Use extra caution when making a "pocket cut" into existing
walls or other blind areas.
Safety Warnings Specific for Sanding Operations:
a) Do not use excessively oversized sanding disc paper. Follow
manufacturers recommendations, when selecting sanding paper.
Safety Warnings Specific for Wire Brushing Operations:
a) Be aware that wire bristles are thrown by the brush even
during ordinary operation. Do not overstress the wires by
applying excessive load to the brush.
b) If the use of a guard is recommended for wire brushing, do
not allow any interference of the wire wheel or brush with the
guard.