Torque Limiter; Storing Various Programs - Nouvag HighSurg 11 Bedienungsanleitung

7.5

Torque limiter

This device comes with a built in torque limiter that works just like a torque wrench.
If the attached instrument detects increasing drag the torque is raised and the speed is reducing, if
necessary up to a stand still. The torque at the instrument persists. If the load on the instrument decreases
the speed picks up again up to its maximal output setting.
The procedure can be followed at, watching the bar graph in the lower right of the display. The segments of
the bar graph are filling up the more drag is building up on the instrument. When maximum torque is
reached, means all segments of the bar graph are visible, the speed is declining. As soon as the load on the
instrument is reduced, the torque decreases and the motor speeds up again.
7.6

Storing various programs

With the HighSurg 11, up to 3 different settings can be set as fixed programs (program 1 to program 3).
Which program is currently active can be seen on the display.
At switch-off, the settings made by the user are automatically saved. This includes the following
parameters:
• Handpiece
• Maximal speed
• Maximal torque
To change a program go to the specific parameter and change it. When the device is switched off all
parameters are saved in that program.
At switch on of the HighSurg 11 the display shows always the last used Program.
14
• Pump On/Off
• Pump performance
• Shaver oscillation period
HighSurg 11, Operating Instructions, Ref. 31998, V14/15
HighSurg 11