Changing The Brake Uid - Benelli LEONCINO 800 2021 Bedienungsanleitung

Rear brake
Front brake uid reservoir
Speci ed brake uid:
DOT 4
WARNING
Improper maintenance can result in
loss of braking ability.
Observe these precautions:
• Insu cient brake uid may allow
air to enter the brake system, re-
ducing braking performance.
• Clean the ller cap before remo-
ving. Use only DOT 4 brake uid
from a sealed container.
• Use only the speci ed brake uid;
otherwise, the rubber seals may
deteriorate, causing leakage.
• Re ll with the same type of brake
uid. Adding a brake uid other
than DOT 4 may result in a harmful
chemical reaction.
• Be careful that water or dust does
not enter the brake uid reservoir
when re lling. Water will signi -
cantly lower the boiling point of
the uid and may result in vapor
lock, and dirt may clog the ABS
hydraulic unit valves.
NOTICE
Brake uid may damage painted surfa-
ces or plastic parts.
Always clean up spilled uid immedia-
tely.
As the brake pads wear, it is normal for the
brake uid level to gradually go down. A
low brake uid level may indicate worn
brake pads and/or brake system leaka-
ge; therefore, be sure to check the brake
pads for wear and the brake system for
leakage. If the brake uid level goes down
suddenly, have a Benelli dealer check the
cause before further riding.
6 - 21
Periodic maintenance and adjustment

Changing the brake uid

Have a Benelli dealer change the brake
uid at the intervals speci ed in the pe-
riodic maintenance and lubrication chart.
EN
6