Replacing The Fuse; Removal And Disposal - HEIDENHAIN EIB 8000 Betriebsanleitung

6.4

Replacing the fuse

The following steps are only to be performed
by electrical specialists.
Further information:
Page 25
WARNING
Danger of electric shock!
When replacing the fuse, there is a possibility of
coming into contact with dangerous live components.
Switch-off the product
Disconnect the power cable from the power supply
NOTICE
Damage to internal parts of the product!
Incorrect fuses may cause damage to the product.
To prevent damage to the product, use only the fuses
given in "Specifications".
Replacing the fuse
Turn the power switch off
Disconnect the power cable from the power source
Push the locking tabs on the fuse holder until they
disengage. For information on the location of the fuse
holder, see "Rear panel", Page 29
Remove the fuse holder and replace the fuse
Insert the fuse holder again and press lightly until it
snaps into place
HEIDENHAIN | EIB 8000 | 09/2018
"Personnel qualification",
7

Removal and disposal

7.1 Overview
This chapter contains information and environmental
protection specifications that must be observed for
correct disassembly and disposal of the product.
The following steps must be performed only
by qualified personnel.
Further information:
Page 25
NOTICE
Depending on the connected peripherals, special safety
precautions may be required.
Comply with the corresponding safety precautions,
which are given when installing the relevant
components, see "Installation", Page 28
7.2 Disassembly
Storage after removal
If the unit will be temporarily stored after removal, the
specified ambient conditions must be maintained.
Further information: "Specifications", Page 36
Pack the device for storage
Repackaging should correspond to the original packaging
as closely as possible:
Re-attach all connection parts to the product as they
were attached when received from the factory, or
repackage them in the original packaging as received
from the factory.
Repackage the product, foam and cardboard box insert
as originally shipped from the factory
Place all other components in the original packaging as
received from the factory.
supplied", Page 26
Enclose all the documentation that were included in
the original packaging. Further information:
and distribution of the documentation", Page 23
When returning the device to the Service
Department, accessories and measuring
devices need not
"Personnel qualification",
Further information: "Items
"Storage
be returned with the device.
35