AEG Powertools WS 700-100 Gebrauchsanleitung Seite 5

Electronics
Speed selection
(WSE 700-115)
Mounting the
protective cap
Fitting the
working tool
ENGLISH
The speed of rotation is adjusted electronically when the load increases.
Under the effect of extreme electromagnetic interferences from the outside, tempo-
rary variations in the speed of rotation could arise in particular cases.
Speed pre-selection with the setting wheel:
A = lowest speed
G = highest speed
Slide the protective guard onto the clamping col-
lar. If necessary, loosen the clamping screw some
turns.
Position the protective guard according to the re-
quirements and tighten the clamping screw until
the protective guard is firmly seated.
With the clamping screw tightened, the protective
guard should no longer be able to be moved. Take
care that the grinding disk can be freely turned.
Always disconnect the plug from the socket before carrying out any work on the
machine.
Lock the work spindle by depressing the spindle
lock. Mount the tension flange, the working tool,
and the adjusting nut as shown in illustration.
Loosen respectively tighten the djusting nut with a
pin-type face spanner.
# WS 700-100, WS 700-115, WS 700-125, WSE 700-115