EN GLI SH
Usage
Your impact tool generates the following output
torque:
Cat #
Ft.-Lbs.
In.-Lbs.
DCF813
96
DCF815
79
CAUTION: Ensure fastener and/or
system will withstand the level of torque
generated by the tool. Excessive torque
may cause breakage and possible
personal injury.
1. Place the socket on the fastener head. Keep
the tool pointed straight at the fastener.
2. Press switch to start operation. Always check
torque with a torque wrench, as the fastening
torque is affected by many factors including the
following:
•
Voltage: Low voltage, due to a nearly
discharged battery, will reduce fastening
torque.
•
Socket size: Failure to use the correct
socket size will cause a reduction in fastening
torque.
•
Bolt Size: Larger bolt diameters generally
require higher fastening torque. Fastening
torque will also vary according to length,
grade, and torque coefficient.
•
Bolt: Ensure that all threads are free of rust
and other debris to allow proper fastening
torque.
•
Material: The type of material and surface
finish of the material will affect fastening
torque.
•
Fastening Time: Longer fasten ing time
results in increased fastening torque. Using
a longer fastening time than recom mended
could cause the fasteners to be overstressed,
stripped or damaged.
MAINTENANCE
Your D
WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk
of serious personal injury, place
the forward/reverse button in
the lock-off position or turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories.
38
The charger and battery pack are not serviceable.
There are no serviceable parts inside.
Nm
1150
130
Lubrication
950
107
Your power tool requires no additional lubrication.
Cleaning
CHARGER CLEANING INSTRUCTIONS
Optional Accessories
Consult your dealer for further information on the
appropriate accessories.
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
WARNING: Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.
WARNING: Since accessories, other
than those offered by D
WALT, have
E
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D
WALT, recommended
E
accessories should be used with this
product.
WARNING: Use only impact
accessories. Non-impact accessories
may break and cause a hazardous
condition. Inspect accessories prior
to use to ensure that they con tain no
cracks.