Maintenance; Optional Accessories; Protecting The Environment - DeWalt XR LI-ION DCF610 Originalanweisungen

3. Hold tool firmly with both hands to control the
twisting action of the tool.
WARNING: The screwdriver may
stall if overloaded causing a sudden
twist. Always expect the stall. Grip the
screwdriver firmly with both hands to
control the twisting action and avoid
injury.
4. IF the Screwdriver STALLS, it is usually because
it is being overloaded or improperly used.
RELEASE TRIGGER IMMEDIATELY, remove
bit from work, and determine the cause of
stalling. DO NOT CLICK TRIGGER ON AND
OFF IN AN ATTEMPT TO START A STALLED
SCREWDRIVER — THIS CAN DAMAGE THE
SCREWDRIVER.
5. To minimize stalling or breaking through the
material, reduce pressure on the screwdriver
and ease the bit through the last fractional part
of the hole.
6. Keep the motor running when pulling the
bit back out of a hole. This will help prevent
jamming.
7. With variable speed screwdrivers, there is
no need to center punch the point to be
drilled. Use a slow speed to start the hole and
accelerate by squeezing the trigger harder when
the hole is deep enough without the bit skipping
out.

MAINTENANCE

Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk
of serious personal injury, place
the forward/reverse button in
the lock-off position or turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories.
The charger and battery pack are not serviceable.
There are no serviceable parts inside.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
E
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
EN GL IS H
WALT, have
E
WALT product
E
35