Assembly And Adjustment; Maintenance - DeWalt DW292 Anleitung

Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor size
2
is 1.5 mm . When using a cable reel, always unwind
the cable completely. Also refer to the table below.
2
Conductor size (mm )
0.75
1.00
1.50
2.50
4.00
Voltage Amperes
115 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0

Assembly and adjustment

Prior to assembly and adjustment always
unplug the tool.
Fitting and removing sockets
Your DW292 impact wrench uses a 1/2" square
drive system with detent pin.
Your DW294 impact wrench uses a 3/4" square
drive system with detent pin.
Fitting sockets (fig. B)
• Align the hole (6) in the side of the socket with
the detent pin (5) on the anvil.
• Push the socket (4) onto the anvil (3) until it snaps
into place. Tap it lightly if required.
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5 15 25 30 45
Cable rating (Amperes)
6 6 6 6
6 6 6 6 15
6 6 10 15 20
10 10 15 20 20
15 15 20 25 25
20 20 25 -
6 6 6 6
6 6 6 6
6 6 6 6 10
10 10 10 10 15
15 15 15 15 20
20 20 20 20 25
Removing sockets (fig. C)
• Depress the detent pin (5) through the hole (6) in
the socket and pull the socket off the anvil.
Setting the direction of rotation (fig. D)
• Select forward or reverse rotation using the
forward/reverse switch (2).
Instructions for use
60
Screwdriving or nutsetting (fig. A)
6 10
• Select the appropriate socket for the screw or
15
nut to be driven.
20
• Select forward or reverse rotation as described
25
above.
-
• Hold the tool in line with the fastener.
- -
6 6
Switching ON and OFF (fig. A)
6 6
• To run the tool, press the ON/OFF-switch (1).
15
• To stop the tool, release the switch.
15
20
Various types of sockets, holders and adaptors are
-
available as an option. Consult your dealer for further
information on the appropriate accessories.

Maintenance

Your D WALT Power Tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your Power Tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Always wait until the motor has come to
a complete standstill before changing the
direction of rotation.
Always observe the safety instructions
and applicable regulations.
E N G L I S H
19