Switching The Cordless Magnetic Lamp On/Off/Setting Motion Sensor; Function; Cleaning And Storage; Troubleshooting - LIVARNO LUX 970-G Bedienungs- Und Sicherheitshinweise

The charging time is approx� 3-4 hours� The
charge indicator
3
cordless magnetic lamp is fully charged� As
soon as the cordless magnetic lamp
fully charged, the charge indicator
green� You can then unplug the USB mains
adaptor from the power outlet socket and
disconnect the USB charging cable
the cordless magnetic lamp
z Switching the cordless
magnetic lamp ON/OFF/
Setting motion sensor

function

The cordless magnetic lamp can be
„
switched on or off using the ON/OFF/
AUTO switch �
5
The cordless magnetic lamp has two
„
functions: permanently on and 30-second
timer function when the motion sensor
triggered� For the permanently on function,
slide the ON/OFF/AUTO switch
side of the lamp to the ON position�
To activate the motion sensor
only operates in the dark (approx� 16 lux
or below), set the ON/OFF/AUTO switch
to the position AUTO� The cordless
5
magnetic lamp will then switch on
automatically for 30 seconds whenever
movement is detected within the motion
sensor's detection range of 3-4 metres� The
lamp will switch off again automatically
after that time� To completely switch off the
cordless magnetic lamp, set the ON/OFF/
AUTO switch to the centre, OFF,
5
position (see Fig� A)�
z Cleaning and storage
Risk of electric shock!
There is a risk of electric shock from parts
that carry electric current� Unplug the USB
mains adapter from the power outlet socket
before attempting to clean the lamp�
Risk of damage!
remains red until the
is
1
shows
3
from
11
�
1
6
on the
5
, which
6
Cleaning the cordless magnetic lamp and
accessories incorrectly could damage them�
Before cleaning the cordless magnetic
„
lamp, always switch it off and remove the
USB charging cable�
Do not use corrosive cleaning agents,
„
brushes with metal or nylon bristles or not
sharp or metallic cleaning implements such
as knives, hard spatulas or similar items�
They may damage the surfaces�
Never clean the cordless magnetic lamps
„
or accessories under running water�
Wipe down the cordless magnetic lamps
„
and accessories with a slightly moistened
cloth�
Wipe the cordless magnetic lamps and
„
accessories completely dry�
When the cordless magnetic lamp is not in
„
use, store it in a dry place and make sure it
is switched off�
is
z Troubleshooting
= Fault
= Cause
= Solution
= The lamp does not light up�
= The battery needs charging�
= Charge the cordless magnetic lamp
via the micro-USB socket using the
USB charging cable supplied� The
charging time is approx� 3-4 hours�
= The charge indicator does not light
up when the lamp is being charged�
= There is no power supply to the
cordless magnetic lamp�
= Please check whether your mains
adaptor and the USB charging cable
are properly connected�
z Disposal
Note the label on the packaging
materials when separating the
b
a
29
GB