Scope Of Delivery; Description Of Functions; Overview; Technical Data - Parkside PTSG 140 C2 Originalbetriebsanleitung

Scope of delivery

Unpack the device and check for complete-
ness. Dispose of the packaging material
properly.
- Disc sanding device
- Sanding disc
- Screw clamp
- Angle stop
- 6 x sanding paper
- 2x granulation 80
- 2x granulation 150
- 2x granulation 240
- Angle adapter and adapter for exter-
nal dust extraction
- Hexagon socket wrench
- Operating instructions

Description of functions

Please refer to the descriptions below for
information about the operating devices.

Overview

1 Sanding disc
2 Speed regulator
3 On/off switch
4 Receptor
5 Mains plug
6 Angle scale
7 Screw
8 Washer
9 Screw
10 Sanding table holder
11 Sanding table
12 Slot
13 Angle stop
13a Rail
13b Screw
14 Angle adapter
15 Adapter for external dust
extraction
16 Screw clamp
17 Hexagon socket wrench
18 Sanding paper
19 Knurled nut

Technical Data

Disc sander ................ PTSG 140 C2
Rated input voltage ..........230 V~, 50 Hz
Power input ............... 140 W (S6 30%)*
Power consumption P
Idling speed (n ) ..............max. 4000 min
0
Safety class ..................................... II
Protection category...........................IPX0
Weight ....................................... 2,4 kg
Sanding disc diameter ................ 125 mm
Sound pressure level
(L ) ................... 63,2 dB(A); K
pA
Sound power level (L
measured .......... 76,2 dB(A); K
Total vibration value (a
Operating mode S6 30%: Continuous op-
eration with intermittent load (cycle time 10
min). In order not to heat the motor more
than permitted, the motor may only be op-
erated for 30% of the cycle time with the
stated nominal power and must then continue
running for 70% of the cycle time without a
load.
** Operating mode S1: Continuous operation
with constant load
Levels of noise were determined according
to the norms and regulations in the decla-
ration of conformity.
Wear hearing protection.
The specifi ed total vibration value and the
stated noise emission value have been
measured according to a standardised test
method and can be used to compare one
power tool with another.
GB NI CY
........100 W (S1)**
0
= 3 dB
pA
)
WA
= 3 dB
WA
) ......... 2,5 m/s
h
-1
2
5