Setting The Radio-Controlled Alarm Clock Into Operation - Auriol Z31961A Bedienungs- Und Sicherheitshinweise

e,
um
the
m im-
ke
nto
es.
tery
f
96487_aur_Funkwecker_Content_LB3.indd 15
Do not place the device near to sources of interference
such as televisions, computers, thick walls, etc. These
may disrupt reception of the radio signal.
Do not use the clock in reinforced concrete buildings,
e. g. airports, high-rises, factories or basements. This
can seriously disrupt reception of the radio signal.
Do not start radio reception in a moving vehicle, e. g.
car or train. Reception of the radio signal by the device
can disrupt the vehicle electronics.
Do not expose the clock to temperatures below --20 °C
for any length of time.
Setting the radio-controlled alarm
clock into operation
Remove the protective foil before first use.
Open the battery compartment
clock.
Insert two AAA batteries.
Note: Make sure that the polarity is correct when
you insert the batteries. This is indicated in the battery
compartment.
on the back of the
20
GB/IE 15
16.01.14 12:41