Ecler CA200Z Bedienungsanleitung Seite 68

GEQ_GAIN <Zone=ZA:ZD>
XOVER_ACTIVE <Zone=ZA:ZD>
XOVER_TYPE <Zone=ZA:ZD>
XOVER_FREQUENCY <Zone=ZA:ZD>
COMPRESSOR_ACTIVE <Zone=ZA:ZD>
COMPRESSOR_THRESHO <Zone=ZA:ZD>
LD
COMPRESSOR_RATIO <Zone=ZA:ZD>
COMPRESSOR_ATTACK <Zone=ZA:ZD>
COMPRESSOR_RELEASE <Zone=ZA:ZD>
COMPRESSOR_KNEE <Zone=ZA:ZD>
COMPRESSOR_GAIN <Zone=ZA:ZD>
DELAY_ACTIVE <Zone=ZA:ZD>
DELAY_TIME <Zone=ZA:ZD>
<Band=B1:B10> <Gain=dBx10
>
ON/OFF
LP/HP
<Frequency=Hz>
ON/OFF
<Threshold=dBx10>
<Ratio=x100>
<AttackTime=msx10>
<ReleaseTime=msx10
>
SOFT/HARD
<Gain=dBx10>
ON/OFF
<DelayTime=msx10>
68
Sets the current GAIN (dBx10) of one BAND (B1 to B10) of the
GRAPHICAL EQUALIZER for the specified output zone
Sets the current CROSSOVER FILTER status (ON or OFF) for the
specified output zone
Sets the current CROSSOVER FILTER TYPE (LP or HP) for the
specified output zone
Sets the current CROSSOVER FILTER FREQUENCY (Hz) for the
specified output zone
Sets the current COMPRESSOR status (ON or OFF) for the specified
output zone
Sets the current COMPRESSOR THRESHOLD LEVEL (dBx10) for the
specified output zone
Sets the current COMPRESSOR RATIO (x100) for the specified output
zone
Sets the current COMPRESSOR ATTACK TIME (milliseconds x10) for
the specified output zone
Sets the current COMPRESSOR RELEASE TIME (milliseconds x10) for
the specified output zone
Sets the current COMPRESSOR KNEE mode (SOFT or HARD) for the
specified output zone
Sets the current COMPRESSOR GAIN (dBx10) for the specified output
zone
Sets the current DELAY status (ON or OFF) for the specified output
zone
Sets the current DELAY TIME (milliseconds x10) for the specified
output zone