Ecler CA200Z Bedienungsanleitung Seite 65

TYP PARAM1
E
SET AUTOLOAD_PRESET1
PRESET_NUMBER
LOAD_PRESET
SAVE_PRESET
REMOTE_MODE
REMOTE_INPUTS
REMOTE_ZONES
DISPLAY_MODE
LCD_CONTRAST
EXT_MUTE_ZONES
IN_LABEL
IN_STEREO
PARAM2 PARAM3
ON/OFF
<Preset=P1:P20>
<Preset=T1:T9>
<Preset=P1:P20>
<Preset=T1:T9>
<Preset=P1:P20> "<Name>"
<Remote=R1:R4> <RemoteMode>
<Remote=R1:R4> <Inputs=I1:I6>
<Remote=R1:R4> <Zones=ZA:ZD>
<DisplayMode>
<Contrast=0:100
>
<Zones=ZA:ZD>
<Input=I1:I6> "<Label>"
<Input=I3:I6> ON/OFF
PARAM4 DESCRIPCIÓN
Sets the current AUTOLOAD_PRESET1 at Startup function
Sets (loads) the current PRESET number
Sets (loads) the current PRESET number (same function as
PRESET_NUMBER)
Saves the current configuration into a certain PRESET position (from
P1 to P20) and with a certain LABEL, or name (between quotation
marks to allow for blank characters in the label)
Sets the working mode for a certain REMOTE port (from R1 to R4).
Valid working modes are: DISABLED, IN_VOL, ZONE_VOL, IN_SEL,
IN_SEL_IN_LEVEL, IN_SEL_ZONE_VOL, PRESET, PRESET_ZONE_VOL
Sets the list of inputs affected by the working mode of a certain
REMOTE port (from R1 to R4). Inputs parameter can include I1 to I6,
separated by comma characters and no blank space (example: I1,I2,I3)
Sets the list of outputs affected by the working mode of a certain
REMOTE port (from R1 to R4). Zones parameter can include ZA to ZD,
separated by comma characters and no blank space (example:
ZA,ZC,ZD)
Sets the current LCD DISPLAY MODE (NORMAL or DIMMED or OFF)
Sets the current LCD DISPLAY CONTRAST level
Sets the list of outputs to be muted by an external contact closure,
connected to the MUTE port. Zones parameter can include ZA to ZD,
separated by comma characters and no blank space (example:
ZA,ZC,ZD)
Sets the current LABEL (name) for the specified INPUT (between
quotation marks to allow for blank characters in the label)
Sets the current STEREO link status (ON or OFF) for INPUTs 4 and 5
65