Ecler CA200Z Bedienungsanleitung Seite 37

two values are valid [1, 2], being "1" the highest priority level and "2" the lower
one.
•
<Error ID> is a numerical value for an error code.
•
"<Error Description>"
error description.
DAM514 / DAM614 NOTES:
•
<RemoteMode>
Originally designed to connect WPmVOL-SR (or WPTOUCH) wall panels to the
REMOTE ports in the DAM514 / DAM614: panels that include a volume control
knb and a 5-position selector knob. The possible working modes
command) of any of the 4 available remote ports (R1 to R4) in the unit are:
o DISABLED
o IN_VOL: volume control for one or several inputs (general input volume,
affecting all the post processing)
o ZONE_VOL: volume control for one or several zone outputs
o IN_SEL: one input (source) selection for one or several output zones (with
the 5 position selector)
o IN_SEL_IN_LEVEL: one input (source) selection for one or several output
zones (with the 5 position selector) + the control of the selected input's
crosspoints level to the destination zones
o IN_SEL_ZONE_VOL: one input (source) selection for one or several output
zones (with the 5 position selector) + the control of the affected zones
output volume
o PRESET: a preset recovery, from P1 to P5 (with the 5 position selector)
o PRESET_ZONE_VOL: a preset recovery, from P1 to P5 (with the 5 position
selector) + volume control for one or several zone outputs
o MATRIX_VOL:
•
PAGER / DUCKER
o INPUT 6 can be used with the Talkover feature in PAGER or DUCKER mode.
PAGER mode requires an external paging station (MPAGE4) to select the
destination zones and performing the paging (for DAM614)
o INPUTs 3, 4 and 5 can be used with the Talkover feature just in DUCKER
mode (for DAM614)
o INPUT 5 can be used with the Talkover feature in PAGER or DUCKER mode.
PAGER mode requires an external paging station (MPAGE4) to select the
destination zones and performing the paging (for DAM514)
o INPUT 4 can be used with the Talkover feature just in DUCKER mode (for
DAM514)
is a text chain inside double quotation marks, containing an
parameter
parameter for TALKOVER_MODE
37
(REMOTE_MODE
command: