Ecler CA200Z Bedienungsanleitung Seite 59

XOVER_ACTIVE
XOVER_TYPE
XOVER_FREQUENCY
TYPE PARAM1 PARAM2
INC/DE PRESET_NUMBER <Count>
C
IN_VOL <Input=I1:I5>
IN_BASS <Input=I1:I5>
IN_MID <Input=I1:I5>
IN_TREBLE <Input=I1:I5>
XLEVEL <Input=I1:I5>
ZONE_VOL <Zone=ZA:ZD>
GEQ_GAIN <Zone=ZA:ZD>
TYPE PARAM1
ERROR <Error ID>
ERROR CODES
<Zone=ZA:ZD> ON/OFF
<Zone=ZA:ZD> LP/HP
<Zone=ZA:ZD> <Frequency=Hz>
PARAM3
<Count>
<Count>
<Count>
<Count>
<Zone=ZA:ZD>
<Count>
<Band=B1:B10>
PARAM2 PARAM3
"<Error Description>"
Shows the current CROSSOVER FILTER status (ON or OFF) for the
specified output zone
Shows the current CROSSOVER FILTER TYPE (LP or HP) for the
specified output zone
Shows the current CROSSOVER FILTER FREQUENCY (Hz) for the
specified output zone
PARAM4 DESCRIPCIÓN
INCrements / DECrements the current active PRESET number
Increments / decrements a certain INPUT's current VOLUME. The increment
applied is defined by the Count parameter (dBx10)
Increments / decrements a certain INPUT's current BASS tone LEVEL. The
increment applied is defined by the Count parameter (dBx10)
Increments / decrements a certain INPUT's current MIDDLE tone LEVEL. The
increment applied is defined by the Count parameter (dBx10)
Increments / decrements a certain INPUT's current TREBLE tone LEVEL. The
increment applied is defined by the Count parameter (dBx10)
<Count> Increments / decrements a certain CROSSPOINT current VOLUME (matrix level
sent from one input to one output). The increment applied is defined by the
Count parameter (dBx10)
Increments / decrements a certain output ZONE current VOLUME. The increment
applied is defined by the Count parameter (dBx10)
<Count> Increments / decrements, in a certain output ZONE, the current GAIN for a certain
GRAPHICAL EQUALIZER band. The increment applied is defined by the Count
parameter (dBx10)
PARAM4 DESCRIPCIÓN
Informs about an error
59