Group Separation - Selve commeo Receive Betriebsanleitung

iveo initial operation/Setting

6.7. Group separation

A group is an assembly of several motors/receivers that can be
controlled by one transmitter/channel. This transmitter is dele-
ted after the end of the group separation. During group sepa-
ration, each motor/receiver will only once move randomly for
3 seconds within a period of time of approx. 2 minutes. Stop-
ping the motor with any transmitter will programm this trans-
mitter into the respective motor.
First press the STOP button and then the UP and DOWN but-
tons as well. Keep all three buttons pressed for 9 seconds, in
order to start the group separation (wait until the transmitter
control light flashes three times). The motor indicates activation
of group separation by a short run. Then each motor will move
randomly for 3 seconds within a period of about 2 minutes.
Within the 3-second time slot, stop the movement of the motor
using the STOP button on the transmitter to be programmed.
Then the transmitter is programmed, and the motor has left the
group separation mode.
Fuse
3 s 3 s
Window 1
3 s
Transmitter 1
Every motor/receiver moves randomly only for 3 seconds within
about 2 minutes. The motor/receiver in question must be stop-
ped by the selected transmitter during the movement.
3 s
Window 2
3 s
Transmitter 2
➧
Window 3
3 s
Transmitter 3
49
EN
➧
9 s
EN