Selve Commeo/Iveo Radio - Selve commeo Receive Betriebsanleitung

General

3.2. SELVE commeo/iveo radio

All SELVE commeo Receive receive radio signals on 868.1 MHz
(commeo radio) and 868.3 MHz (iveo radio). The two radio
systems can not be operated at the same time.
commeo is a bidirectional radio system that saves data in the
receiver as well as the transmitter. iveo is an unidirectional radio
system.
The receiver is compatible with both radio systems after it has
been disconnected from the mains supply as long as the
teaching process for a commeo/iveo transmitter has not al ready
been completed. If you wish to change the radio system retro-
spectively, the programming for all transmitters of the other
radio system must be re-programed. The receiver must then be
disconnected from the mains supply.
All SELVE commeo/iveo transmitters can be programmed into
these receivers. Up to 16 transmitters can be programmed into
one motor. Please adhere to the transmitter operating
in structions.
The commeo receiver can be set for different applications in the
CONFIGURATION mode. The commeo Receive is already set
for 'awning'. To operate the commeo receiver, it is necessary to
set the runtime of the blind. The runtime is not set from the
factory. An error message appears in the operating mode.
During iveo operation a change of the receiver application is not
possible.
Note:
Ensure that the controls are not installed and operated in the
vicinity of metal surfaces or magnetic fields. Metal surfaces or
panes of glass with a metallisation within the transmission path
can reduce the range considerably.
Radio sets transmitting at the same frequency could interfere
with reception.
It should be noted that the range of the radio signal is restricted
by legislation and constructional measures.
33
EN
EN