Functions In Service Mode; Resetting The Runtime - Selve commeo Receive Betriebsanleitung

iveo initial operation/Setting

6.3. Functions in service mode

In order to carry out the following settings, the receiver has to
be put into service mode by disconnecting it from the mains
supply in a special way.
Consider the following:
• Transmitter programmation has to be finished before service
mode can be executed.
• Put only the receiver which is to be set into service mode.
• The receiver remains in service mode for 4 minutes.
• In order to leave the service mode just drive the motor/
receiver up or down.
Fuse
3 s 3 s
The receiver confirms the service mode by a brief up and down
moving.

6.4. Resetting the runtime

Setup-mode can only be finished by programming both end
positions.
The transmitter assignment is not affected by this. When setting
the end positions, the motor/receiver is in the normal operating
state again.
Put the motor/receiver into service mode by disconnecting it.
Press the STOP button of an assigned transmitter for 6 seconds
to return the motor/receiver to setting mode (wait until the
transmitter indicator flashes twice). Then set the runtime as
described in the grey section for item 6.
Fuse
3 s 3 s
3 s
3 s
Assigned transmitter
STOP
6 s
➧
47
EN
EN