Programming/Deleting Transmitters; Delete Transmitter Table In The Receiver - Selve commeo Receive Betriebsanleitung

commeo initial operation/Setting
Note for settings under point 5.2.: The motor/receiver must
be selected for this setting with a transmitter in SELECT mode
(Status LED flashes slowly in orange). After completing the
setting, the motor/receiver is still selected (see point 5.).

5.2.2. Programming/deleting transmitters

To program or deprogram a transmitter, select the desired
channel and push the PROG button for 1 second. The status
LED lights up green to indicate that the transmitter has been
programmed. A red light means that the transmitter has been
deprogrammed.
1 s

5.2.3. Delete transmitter table in the receiver

To delete the transmitter table in the receiver, push the PROG
button on the transmitter for 6 seconds. All transmitters
programmed in the receiver are deleted. The programmed
receiver has been cancelled in the transmitter.
Note: This causes an error message if there are
any more programmed receivers!
If this receiver in operating mode moves over a trans-
mitter which is still programmed, the transmitter will
6 s no longer receive a response and will acknowledge
this with an error message.
Status LED transmitter = green
 transmitter programmed
Status LED transmitter = red
 transmitter deleted
39
EN
EN