Delete Runtime/Rotation Direction And Setting Of The Runtime And The Rotation Direction - Selve commeo Receive Betriebsanleitung

EN commeo initial operation/Setting
Note for settings under point 5.2.: The motor/receiver must
be selected for this setting with a transmitter in SELECT mode
(Status LED flashes slowly in orange). After completing the
setting, the motor/receiver is still selected (see point 5.).
5.2.1. Delete runtime/rotation direction and setting of the
runtime and the rotation direction
A one-off stop indicates the setting of the runtime/rotation
direction. To set the runtime/rotation direction, first approach
the lower end position to start programming the runtime/run-
ning direction. Then approach to the upper end position to
complete the setting.
Operation
6 s
or
3 s
or
3 s
Drive
Press the STOP button of the
transmitter for 6 seconds.
Note: Not required for the
initial installation.
Move the blind to the lower
end position with the UP or
DOWN button.
Press the STOP button of the
transmitter for 3 seconds.
The correct rotation direction
assignment will be carried out
at the end of the end position
setting.
Move to the upper end
position.
Press the STOP button of the
transmitter for 3 seconds.
The runtime/rotation direction
is now set. Perform a test run.
38