Group Separation - Selve commeo Receive Connect Betriebsanleitung

iveo initial operation/Setting

5.8. Group separation

A group is an assembly of several motors/receivers that can be con-
trolled by one transmitter/channel.This transmitter is deleted after the
end of the group separation. During group separation, each motor/
receiver will only once move randomly for 3 seconds within a period
of time of approx. 2 minutes. Stopping the motor with any transmitter
will programm this transmitter into the respective motor.
First press the STOP button and then the UP and DOWN buttons as
well. Keep all three buttons pressed for 9 seconds, in order to start
the group separation (wait until the transmitter control light flashes
three times). The motor indicates activation of group separation by a
short run. Then each motor will move randomly for 3 seconds within
a period of about 2 minutes. Within the 3-second time slot, stop the
movement of the motor using the STOP button on the transmitter to
be programmed. Then the transmitter is programmed, and the motor
has left the group separation mode.
Fuse
3 s 3 s 3 s
Window 1
3 s
Transmitter 1
Every motor/receiver moves randomly only for 3 seconds within
about 2 minutes. The motor/receiver in question must be stopped by
the selected transmitter during the movement.
➧
Window 2 Window 3
3 s
Transmitter 2 Transmitter 3
9 s
3 s
47
GB
➧
GB