Changing The Radio System To Commeo - Selve commeo Receive Betriebsanleitung

EN iveo initial operation/Setting
If the motors/receivers are still moving together, repeat the
procedure for the motors/receivers affected.
If you did not programm a transmitter through the STOP button
and no other transmitter is programmed, you may programm
this transmitter again by pressing the UP and DOWN buttons
at the same time and then pressing the PROG button.

6.8. Changing the radio system to commeo

To change the radio system of a motor/receiver with iveo trans-
mitters, first set the motor/receiver to service mode and then
select the motor/receiver using a commeo transmitter by
pressing the SELECT button for 3 seconds. When the motor/
receiver has been selected, all iveo transmitters have been re-
programmed.
Fuse
➧
3 s 3 s 3 s 3 s
50