EN iveo initial operation/Setting
6.1. Programming transmitters/channels
6.1.1. Programming further transmitters/channels
Press the PROG button of a programmed transmitter/channel
for 3 seconds (wait for confirmation run from the motor/ receiver).
The motor/receiver is now in programme mode for 1 minute.
Press (1 sec.) the PROG button of the new transmitter/channel.
The new transmitter/channel has now been programmed.
Programmed
transmitter/channel
➧
3 s
6.1.2. Deleting of transmitters/channels
Press the PROG button of a programmed transmitter/channel
for 3 seconds (wait for confirmation run from the motor/ receiver).
The motor/receiver is now in programme mode for 1 minute.
Press (1 sec.) the PROG button of the transmitter/channel you
wish to delete. The transmitter/channel has now been deleted.
Programmed
transmitter/channel
➧
3 s
6.2. Intermediate positions
For setting and calling the intermediate positions, see the trans-
mitter instructions.
New
transmitter/channel
1 s
Transmitter/channel
to be deleted
1 s
46