Installation/Connection - Selve commeo Receive Betriebsanleitung

EN Installation/Connection

4. Installation/Connection

Safety instructions
• Risk of injury through an electric shock.
• Terminal connections must be carried out by an
Warning!
authorised electrician.
• Only the back of the hand is protected by the
device, no protection against accidental contact.
Warning!
• Do not bend, shorten or add extensions to the
antenna.
• If more than one motor is being controlled via the
commeo Receive, the motors must be decoupled
by relay controls. The switched current of the device
must be observed at all times.
1. Connect the commeo Receive as follows:
Extension input (230 V)
DOWN
UP
1. Lamp encoding terminal
2. Venetian blind encoding terminal
2. Programme a transmitter into the receiver (see section Initial
operation).
Note: Ensure that optimum radio reception is achieved.
34