Iveo Initial Operation/Setting - Selve commeo Receive Betriebsanleitung

iveo initial operation/Setting

6. iveo initial operation/Setting
iveo initial operation
The iveo initial operation is possible using any iveo transmitter
which has UP, STOP and DOWN buttons.
Operation
1 s
1 s
or
3 s
or
3 s
Drive
Press the UP and DOWN
buttons at the transmitter at
the same time. The transmitter
is temporarily programmed
into the receiver.
To save the programmed
transmitter, press the PROG
key for one second. The trans-
mitter is now permanently
programmed in the receiver.
Now set the run times:
Move the blind to the lower
end position with the UP or
DOWN button.
Press the STOP button of the
transmitter for 3 seconds.
The correct rotation direction
assignment will be carried out
at the end of the end position
setting.
Move to the upper end
position.
Press the STOP button of the
transmitter for 3 seconds.
The runtime/rotation direction
is now set. Perform a test run.
45
EN
EN