Iveo Initial Operation/Setting - Selve commeo Receive Connect Betriebsanleitung

iveo initial operation/Setting

5. iveo initial operation/Setting
iveo initial operation
The iveo initial operation is possible using any iveo or intronic trans-
mitter which has UP, STOP and DOWN buttons.
Operation
1 s
1 s
or
3 s
or
3 s
Drive
Press the UP and DOWN buttons
at the transmitter at the same time.
The transmitter is temporarily pro-
grammed into the receiver.
To save the programmed transmitter,
press the PROG key for one second.
The transmitter is now permanently
programmed in the receiver.
Now set the run times:
Move the blind to the lower end posi-
tion with the UP or DOWN button.
Press the STOP button of the trans-
mitter for 3 seconds.
The correct rotation direction assign-
ment will be carried out at the end of
the end position setting.
Move to the upper end position.
Press the STOP button of the trans-
mitter for 3 seconds.
The runtime/rotation direction is now
set. Perform a test run.
43
GB
GB