Delete Runtime/Rotation Direction And Setting Of The Runtime And The Rotation Direction - Selve commeo Receive Connect Betriebsanleitung

commeo initial operation/Setting
Note for settings under point 4.2.: The motor/receiver must be
selected for this setting with a transmitter in SELECT mode (Status
LED flashes slowly in orange). After completing the setting, the
motor/receiver is still selected (see point 4.).
4.2.1. Delete runtime/rotation direction and setting of the runtime
and the rotation direction
A one-off stop indicates the setting of the runtime/rotation direction.
To set the runtime/rotation direction, first approach the lower end
position to start programming the runtime/running direction. Then
approach to the upper end position to complete the setting.
Operation
6 s
or
3 s
or
3 s
Drive
Press the STOP button of the trans-
mitter for 6 seconds.
Note: Not required for the initial
installation.
Move the blind to the lower end posi-
tion with the UP or DOWN button.
Press the STOP button of the trans-
mitter for 3 seconds.
The correct rotation direction assign-
ment will be carried out at the end of
the end position setting.
Move to the upper end position.
Press the STOP button of the trans-
mitter for 3 seconds.
The runtime/rotation direction is now
set. Perform a test run.
37
GB
GB