Installation/Connection - Selve commeo Receive Connect Betriebsanleitung

Installation/Connection

3. Installation/Connection
Safety instructions
• Risk of injury through an electric shock.
• Terminal connections must be carried out by an autho-
Warning!
rised electrician.
• If more than one motor is being controlled via the com-
meo Receive Connect, the motors must be decoupled by
Warning!
relay controls. The switched current of the device must
be observed at all times.
1. Connect the commeo Receive Connect as follows:
Mains 230 V/50 Hz
k
STAK3
1: N (blue)
2: L (black)
3: Not used (brown if available)
k: Earth conductor (green-yellow)
• The neutral conductor (blue) is always on clamp 1.
• Specific installation instructions for the connectors
STAK3 and STAS3 need to be observed, e.g.
Warning!
· Indication of the wiring type,
· Indication of the manufacture of tightness,
· Secure both plug connectors by using the securing
clip.
• Install the commeo Receive Connect protected against
direct rain.
2. Programme a transmitter into the receiver (see section Initial ope-
ration).
Note: Ensure that optimum radio reception is achieved.
Motor
STAS3
1: N (blue)
2:
▲
3:
▼
k: Earth conductor (green-yellow)
33
GB
k
GB