Connections - GOK EN61-DS PS 16 bar Montage- Und Bediensungsanleitung

CONNECTIONS

Inlet, optional
Gaskets in the connections must not be damaged and be placed correctly in the frame.
All G. and H. connections according to EN 16129. Other connections may also be used.
Outlet, optional
Artikel-Nr. 01 150 50 f
Trading name and dimensions
acc. to standard
Combinded fitting (Komb.A)
• with polyamide gasket
• G.5 = Thread W 21.8 x 1/14
FR Shell (Shell-F)
• Wing nut, soft with rubber gasket and 5-wing
cap nut
• G.2 = Thread 21.8 x 1/14-LH - 60° ÜM
Small cylinder KLF
• with 5-wing cap nut
• G.12 = Thread W 21.8 x 1/14 ÜM
Italian connection
• with rubber gasket and cap nut
• G.1 = Thread W 20 x 1/14 ÜM
Shell Combi Soft (Komb.Shell-WS)
• X.2
• with gasket and coupling nut
• Thread W 21.8 x 1/14 lh
Soft POL wings connection (POL-WF)
• with rubber gasket and retaining screw
• G.10 = Thread 0.880-14 NGO lh
Trading name and dimensions
acc. to standard
Ball-cone connector
• H.4 = Thread G 1/4-LH-KN
Compression fitting RVS
• H.9 = RVS 10
Screw-in fitting
• H.22 = IG G 1/4
• For accepting a screw-in fitting with O-ring
EN61-DS PS 16 bar
Installation notes
Spanner size 30
Hexagonal
Tighten hand-tight.
Tighten hand-tight.
Spanner size 25
Hexagonal
Spanner size
SW 25
Hexagonal
Spanner size 24
Hexagonal
Installation notes
Torques:
G 1/4 = 5-7Nm
15 / 50