Modes Of Operation - DeLonghi FRIO 12 Installationsanleitung

MODES OF OPERATION

Mode of operation
On/Off/Stand-by.
The symbol
ON/OFF
control display when the conditioner is
switched on. When the unit is switched
off or on, the Timer and Sleep functions
are cancelled.
Every time the FAN button is pressed
the speed changes in the following
FAN
sequence: AUTO - LOW – MEDIUM
(Fan Mode)
– HIGH. If you select the AUTO FAN
speed, the electronic control chooses
the fan speed automatically.
Airflow adjustment. Press the "SWING"
button to start the automatic movement
of the airflow direction adjustment flaps;
press the "SWING" button again to stop
SWING the flaps moving. If this function is started
in the HEAT mode, there will be a slight
delay to ensure an immediate output of
hot air in order to enjoy a comfortable
temperature
function).
Mode of operation selection. Every time
the MODE button is pressed the mode
MODE of operation changes in the following
sequence: SMART - COOLING - DRY -
FAN - HEATING.
The default mode is AUTO.
Setting of temperature. Press once to
by 1°C.
Available range of temperature settings:
- HEATING
TEMP
- COOLING
Down/Up - DEHUMIDIFYNG
- FAN
Setting the timer.
by 0.5h or (-) to decrease the setting by
0.5h.
Do not turn the vertical airflow direction flaps by hand,
since this could cause malfunctioning. In the case of
flap malfunction, first of all switch off the appliance,
disconnect it from the power supply and then recon-
nect it.
Adjustment of horizontal airflow (manual)
To change the angle of the airflow, turn the adjusting cur-
Note: the unit shown here may be different from the air con-
ditioner you have purchased.
This adjustment must be done with the appliance
switched off.
appears on the remote
immediately (Hot-Start
16°C ~ 30°C
16°C ~ 30°C
16°C ~ 30°C
16°C ~ 30°C
Note: the appliance will start in the mode of operation that
was selected before switching off.
flow adjustment.
USER
-
7