Modes Of Operation - DeLonghi Kyoto PLK130 Bedienungsanleitung

MODES OF OPERATION

Mode of operation
On/Off/Stand-by.
ON/OFF
The symbol
control display when the conditioner is
switched on.
Every time the FAN button is pressed
the speed changes in the following
sequence: AUTO - LOW – MEDIUM
FAN
– HIGH. If you select the AUTO FAN
(Fan Mode)
speed, the electronic control chooses
the fan speed automatically.
In AUTO mode, the electronic control
chooses the fan speed.
Airflow adjustment. Press the "SWING"
button to start the automatic movement
of the airflow direction adjustment flaps;
press the "SWING" button again to stop
SWING
the flaps moving. If this function is started
in the HEAT mode, there will be a slight
delay to ensure an immediate output of
hot air in order to enjoy a comfortable
temperature
function).
Mode of operation selection. Every time
the MODE button is pressed the mode
MODE
of operation changes in the following
sequence: SMART - COOLING - DRY -
FAN - HEATING.
Setting of temperature. Press once
to raise (
temperature by 1°C.
TEMP
Available range of temperature settings:
Down/Up
- HEATING
- COOLING
- DEHUMIDIFYNG
- FAN
Do not turn the vertical airflow direction flaps by hand,
since this could cause malfunctioning. In the case of
flap malfunction, first of all switch off the appliance,
disconnect it from the power supply and then recon-
nect it.
Adjustment of horizontal airflow (manual)
To change the angle of the airflow, turn the adjusting cur-
Note: the unit shown here may be different from the air con-
ditioner you have purchased.
This adjustment must be done with the appliance
switched off.
8
appears on the remote
immediately (Hot-Start
) or lower ( ) the set
16°C ~ 30°C
16°C ~ 30°C
16°C ~ 30°C
16°C ~ 30°C
Note: the appliance will start in the mode of operation that
was selected before switching off.
flow adjustment.
USER
!
-