Operation
4. Move choke (32/2) to the "CLOSED" position
(32/b).
5. Press primer button (33/1) 3x at intervals of
approx. 2 seconds. At temperatures below 10
°C, press the primer button 5x.
6. Move throttle lever (34/1) to the Fast position
(34/ 2, Hare) (34/a).
7. Insert engine key (35/1) (35/a).
Manual start (36)
1. Pull the starter cable (36/1) out slightly (36/a)
until initial resistance is felt, then pull out
sharply and allow it to wind back in slowly.
230 V starting process (37)
1.
2.
6.8
Stopping the engine (38, 39)
WARNING! Danger from rotating appli-
ance parts! Reaching into rotating appliance
parts will result in serious injuries!
■
Never reach into the rotating transport auger!
1. Move the throttle lever (38/1) to the "Slow"
position (38/2, Tortoise) (38/a).
2. To prevent freezing, allow transport auger
and discharge wheel to continue to run until
they are more or less free of snow. The V-
belts could otherwise be damaged during
starting.
3. Remove engine key (39/1) (39/a).
4. The engine stops.
5. Turn fuel cock (39/2) to the "OFF" (closed)
position (39/b).
474911_d
7 OPERATION
7.1
Starting clearing (40 - 42)
WARNING! Danger from rotating appli-
ance parts! Reaching into rotating appliance
parts will result in serious injuries!
■
Never reach into the rotating transport auger!
WARNING! Objects being discharged!
Risk of injury and risk of material damage due to
objects being discharged!
■
Never turn the discharge channel in the di-
rection of persons, animals, windows, cars or
doors.
1. Start clearing.
(37/a)
2. Check the position of the snow discharge
spout and adjust the discharge direction us-
ing the hand crank (40/1).
3. Adjust the discharge height (40/2).
4. Start the engine (see chapter 6.7 "Starting
the engine (32 - 37)", page 40).
5. Engage the gear for the travel drive (41/3):
(37/b)
■
■
6. Push clutch lever (41/4) for the auger drive
(41/a).
7. Push clutch lever (42/5) for the travel drive
(42/a).
7.2
Stopping clearing (43)
1. Release the clutch lever (43/1) to disengage
the auger drive and travel drive (43/a).
To prevent freezing, allow transport auger and
discharge wheel to continue to run until they are
more or less free of snow. A frozen transport au-
ger would damage the V-belts.
The snow blower comes to a standstill, transport
auger and discharge wheel stop.
7.3
Changing gear for the travel drive (42 -
44)
IMPORTANT! Risk of damage to the appli-
ance. The transmission is damaged if the clutch
is not disengaged before the gear change.
■
First disengage the clutch, then change
gears.
1. Release clutch lever for the travel drive
(43/1), i.e. disengage (43/a).
Note: The transport auger blocks when it is
1 to 6 are forward gears, with 1 the low-
est and 6 the highest gear.
R1 and R2 are reverse gears, with R1
the lower and R2 the higher gear.
41